AVE Video Serial Synchronous ATM Interface VSSI-PRO Manual de usuario Pagina 109
- Pagina / 138
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
ADPRO FastTrace-R by Xtralis Installation and User Manual
Doc 13972_03 97
If using the Only When ALL Inputs Occur logic, only the first pre-set on the list will be active. If
another Alarm Input is configured for the same PTZ camera, its preset will not be available, and
will be displayed with an (N/A) beside the Preset Position.
Note: Please refer to PTZ Tech Tips for connection and setup information on the website -
www.xtralis.com/adpro.
Editing a Detector’s Preset
To edit a detector’s preset:
1. Double click the event input to be modified. The Event Input Settings dialog box is
displayed.
Figure 97: Event Input Settings
The Type and Source selections are greyed out, enabling the operator to only change the PTZ
Preset Settings.
2. Enter the appropriate settings and click OK.
Event Response
Once an Event has been declared, the Event Response settings are used to define the actions
that will be taken in response to the Event.
Figure 98: Event Response Tab
- ADPRO FastTrace-R 1
- Installation and 1
- User Manual 1
- Contact Us 5
- Declaration of Conformity 6
- Contents 7
- List of Figures 9
- Doc. 13972_03 10
- List of Tables 11
- 1 Introduction 13
- 2 Doc. 13972_03 14
- 2.1 Physical Location 15
- Instructions 16
- 2.3.2 Static Discharge 17
- 2.3.3 Grounding Requirements 17
- 2.4 Unpacking the FastTrace-R 18
- 2.5 Mounting the FastTrace-R 19
- 2.7 Setting up the PC 20
- Doc 13972_03 9 21
- Doc 13972_03 11 23
- Doc 13972_03 13 25
- Null-modem Cable Wiring 27
- Doc 13972_03 17 29
- 2.8 FastTrace-R Configuration 31
- Doc 13972_03 21 33
- 2.10 Adding a New Site 35
- 2.12.2 Front Panel LED 37
- 2.14 Firewall Configuration 38
- 3 FastTrace-R Connectors 39
- 3.1 Power Connection 40
- 3.2.2 COMMS 2 41
- 3.3 Audio 43
- 'AUDIO' 44
- 9-pin DECA Connector 44
- 3.3.3 Audio Configuration 45
- 3.3.4 Zoned Audio 46
- 3.4 Video Input Connections 47
- 3.5 Video Output 49
- 3.6 Configuration Switches 49
- 3.7 Alarm Inputs 51
- Doc 13972_03 41 53
- 3.8 Control Outputs 54
- 3.9 PTZ Connection 55
- 3.9.1 PTZ Port Setup 57
- 3.11 Data Connection 59
- 3.12.4 Push to Talk - Pin 7 61
- 3.12.6 Fault Relay 61
- 4 Programming FastTrace-R 63
- Doc 13972_03 53 65
- 4.3.3 Site Details 67
- 4.3.4 Date/Time Settings 68
- Doc 13972_03 57 69
- 58 Doc 13972_03 70
- 4.3.5 Licensing 71
- 4.3.6 Communications 72
- IP Address for this Unit 73
- Subnet Mask 74
- Default Gateway 74
- Video Data Rate 74
- Doc 13972_03 63 75
- Modem/TA Model 76
- Line Type 76
- Data Rate 76
- Dial Time 76
- Answer Rings 76
- Initialisation String 77
- Redcare Setting 77
- Doc 13972_03 67 79
- Base Port Number 80
- Connection Timeout 80
- Enable WAN Optimisation 80
- PPP Settings 80
- 4.3.7 Connected Equipment 81
- 4.3.8 Cameras 82
- Camera Settings 83
- General Tab 84
- PTZ Settings 85
- Activity Detection Tab 87
- Contrast Monitoring Tab 88
- 4.3.9 Monitor 89
- 4.3.10 Transaction Devices 89
- 4.3.11 Transparent Data Port 90
- Baud Rate 91
- Data Bits 91
- Stop Bits 91
- Flow Control 91
- 4.3.12 Alarm Inputs 92
- 4.3.13 Presidium Inputs 93
- Presidium Input Settings 94
- 4.3.14 Control Outputs 95
- Control Output Settings 96
- 4.3.15 Audio 97
- 4.3.16 Arming / Disarming 98
- 4.3.17 Operational Behaviour 99
- Camera Recording Information 100
- 4.3.18 Operational Modes 101
- Doc 13972_03 102
- 4.3.19 Audio Behaviour 103
- 4.3.20 Camera Behaviour 104
- Video Capture (tab) 105
- Event Triggers 106
- Alarm Logic 107
- Event Inputs 107
- Event Response 109
- Activate Control Output 110
- Generate Alarm on Video Loss 110
- Record Audio on Event 110
- Doc 13972_03 99 111
- Guard Tour Settings 112
- Doc 13972_03 101 113
- 4.3.22 Entry/Exit Behaviour 115
- 4.3.23 Maintenance 116
- Zone Isolate 117
- SitePulse 118
- 5 Event Log 119
- 5.1 Save the Event Log 120
- Doc 13972_03 109 121
- 110 Doc 13972_03 122
- Doc 13972_03 111 123
- 112 Doc 13972_03 124
- Doc 13972_03 113 125
- 114 Doc 13972_03 126
- 6 FastTrace-R Impounding 127
- 116 Doc 13972_03 128
- Doc 13972_03 117 129
- 118 Doc 13972_03 130
- 8.1 Software Upgrade Process 131
- 9 Specifications 133
- 122 Doc 13972_03 134
- Doc 13972_03 123 135
- 124 Doc 13972_03 136
- Tele met ry 136
- Doc 13972_03 125 137
- 126 Doc 13972_03 138
Relacionado con productos y manuales para Redes AVE Video Serial Synchronous ATM Interface VSSI-PRO
Redes AVE Opto 232 Manual de usuario
(33 paginas)
(33 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.037 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales